LIBRARY  |  COMPANIES |   PLATFORMS |   PROCESSORS |   PERIPHERALS
SmscLAN91C111



OVP Peripheral Model: SmscLAN91C111



Model Specific Information

This page provides introductory usage information for an Imperas OVP peripheral behavioral model. The page is split into sections providing specific information for this peripheral, including any ports for connecting into a platform, registers, other component parts, and configuration options and general information for peripheral modeling with Imperas OVP.

Reference

SMSC LAN91C111 10/100 Non-PCI Ethernet Single Chip MAC + PHY Datasheet Revision 1.91 (06-01-09)

Limitations

Not all registers and device features are implemented. Only 16-bit bus interface currently supported.

Description

SMSC LAN91C111

Licensing

Open Source Apache 2.0

Location

The LAN91C111 peripheral model is located in an Imperas/OVP installation at the VLNV: smsc.ovpworld.org / peripheral / LAN91C111 / 1.0.



Peripheral Instance Parameters

This model accepts the following parameters:

Table : Peripheral Parameters

NameTypeDescription
logfilestringThe file to which Ethernet frames should be logged. Uses pcap file format, viewable by Wireshark and other programs
tftpPrefixstringPath to the root of the tftp directory
networkstringThe (v4) IP address of the local network device.
redirstringUser mode redirection of host port to virtual port (using SLiRP), command format <protocol>:<host port>:<ip address>:<virtual port>
tapDevicestringThe name of the TAP device
replaystringReplay external events from this file
pollDelayuns32Sets the delay of the polled reads, default (1000uS)
recordstringRecord external events into this file



Net Ports

This model has the following net ports:

Table 1: Net Ports

NameTypeMust Be ConnectedDescription
irqoutputF (False)IRQ Pin



Bus Slave Ports

This model has the following bus slave ports:

Bus Slave Port: bport1

Table 2: Bus Slave Port: bport1

NameSize (bytes)Must Be ConnectedDescription
bport10x1000F (False)

Table 3: Bus Slave Port: bport1 Registers:

NameOffsetWidth (bits)DescriptionR/Wis Volatile
ab_REG_100xa16
ab_REG_80x816
ab_REG_60x616
ab_REG_40x416
ab_REG_20x216
ab_REG_00x016
ab_BANK_SEL0xe16
ab_REG_120xc16



Packetnet Ports

This model has the following packetnet ports:

Packetnet Port: phy

Table 4: phy

NameMaximum Packet Size (bytes)Must Be ConnectedDescription
phy1524F (False)



Platforms that use this peripheral component

Peripheral components can be used in many different platforms, including those developed by Imperas or by other users of OVP. You can use this peripheral in your own platforms.

Table 5: Publicly available platforms using peripheral 'LAN91C111'

Platform NameVendor
ARMv8-A-FMv1arm.ovpworld.org



SmscPeripherals
Page was generated in 0.0204 seconds